To Next PageTo Next Page
Need help?Do you have a question about the Sony Trinitron PVM-8041Q and is the answer not in the manual?
General| Screen Size | 8 inches |
|---|---|
| Aspect Ratio | 4:3 |
| Display Type | CRT |
| Weight | 6.5 kg |
| Tube Type | Trinitron |
| Input Types | Composite, S-Video |
| Audio | Built-in speaker |
Details for video signal types, resolution, and frequency response.
Parameters for picture quality like linearity, convergence, and stability.
Lists and describes the various input and output connectors.
General technical parameters like power consumption.
Pin details for the 4-pin mini DIN Y/C input connector.
Pin details for the 8-pin mini DIN Tally/Remote connector.
Essential checks for safety before releasing the unit.
Procedures and limits for measuring AC leakage current.
Methods for finding a reliable earth ground connection.
Overview of the monitor's key features and capabilities.
Identifies and describes the location and function of controls and parts.
Details on how to power the monitor using AC or battery.
Step-by-step guide for removing the monitor's outer cabinet.
Instructions for safely removing the B board.
Procedure for removing the switching regulator component.
Steps for removing the D board from the chassis.
Instructions on how to remove the P board.
Guide for removing the rear assembly unit.
Steps for removing the HA and FA boards.
Procedures for removing the picture tube and anode cap.
Important precautions for handling the anode cap.
Procedure for adjusting beam landing for optimal picture geometry.
Procedures for static and dynamic convergence adjustments.
Adjusting static convergence for the center of the screen.
Adjusting dynamic convergence for the screen edges.
Procedure for adjusting the picture focus.
Procedures for adjusting white balance and screen voltage.
Adjusting the G2 voltage for white balance.
Critical adjustments related to safety compliance and operation.
Procedure for confirming B+ voltage maximum limits.
Verifying and readjusting the hold-down circuit.
Confirming B+ voltage during DC power input.
Detailed adjustments for the D board.
Adjusting the horizontal oscillation frequency.
Adjusting screen phase parameters.
Adjusting horizontal and vertical blanking signals.
Adjusting vertical deflection parameters.
Adjusting horizontal deflection parameters.
Adjusting pin amp, phase, angle, and bow distortion.
Adjusting the horizontal and vertical HV delay.
Adjusting the shut-down voltage control.
Adjusting B+ voltage during DC operation.
Adjusting the primary color matrix.
Adjusting the burst gate pulse width.
Adjusting the Voltage Controlled Oscillator.
Adjusting the NTSC comb filter for improved detail.
Adjusting NTSC color demodulation parameters.
Adjusting NTSC 4.43MHz color demodulation.
Adjusting PAL color demodulation parameters.
Adjusting the PAL color signal level.
Adjusting PAL color R-Y signal level.
Adjusting chroma horizontal pulse position.
Adjusting the sub-sharpness control.
Procedures for adjusting SECAM signals.
Adjusting the bell filter for smooth chroma waveform.
Adjusting color balance for flat non-colored portions.
Adjusting demodulation signal levels.
Diagram showing the picture tube assembly and its parts.
List of capacitors used in the unit with part numbers.
List of band pass filters with part numbers.
List of connectors with part numbers.
List of trap modules with part numbers.
List of trimmers with part numbers.
List of diodes with part numbers.
List of integrated circuits with part numbers.
List of coils with part numbers.
List of transistors with part numbers.
List of resistors with part numbers.
List of modules with part numbers.
List of crystals with part numbers.
List of neon lamps with part numbers.
List of transformers with part numbers.
List of miscellaneous components.
Reference to the instruction manual.
Packing material for PVM-8041Q.
Packing material for PVM-8044Q.
