Sony Trinitron PVM-4300 - Front Panel Control Details

[3
STANDBY indicator
Illuminates when
the power is turned
off
by the remote
commander and the
unit is
set
in the standby mode.
[T]
POWER
indicator
Illuminates when the
power
is
turned on.
0
Remote
control detector
The beam from the
remote commander is received here.
0
POWER switch
Press this switch to turn on the
monitor.
Press it again to
turn off
the
monitor.
0
RGB INPUT
MODE selector
Set to
31
.5
kHz when connecting an
equipment with 31
.5
kHz
horizontal frequency to the RGB
(31
.5
kHz) input
connector. Otherwise, set to
15.75 kHz,
0
WIRELESS
ON/OFF switch
Normally
set
to ON. Set to OFF so that the
remote
control detector does
not
accept
the beam from the
remote
commander.
0
WIRED IN ON/OFF
switch
Normally
set to
ON, and the control S signal can be
input
to
the monitor. Set to
OFF
not
to
input
the control S
signal to the
monitor.
0
MANUAL
ON/OFF
switch
Normally set to ON. Set to OFF so that
the all controls
and buttons
on the front panel cannot
be operated.
0
COLOR TEMP
(temperature)
selector
Use this selector to
adjust the color temperature.
0
V HOLD
(vertical hold) control
When
the
picture rolls vertically,
correct
it
with this
control.
0
STILL
button
Press this button to view the
still picture. Press this
button again
to
restore the normal picture.
OH
VOLUME control buttons
Press +
to
raise the
volume
or
-
to lower it.
jo] PICTURE control buttons
Press +
to
increase the contrast or
-
to
decrease it.
0
RGB button
Press this button to
monitor
the signal
fed
through the
RGB input connectors to the monitor.
®
VIDEO
1,2,
3
buttons
Press each button to select the
VTR connected
to the
respective VIDEO
1,
2,
3
connector.
0
RESET button
Press
this
button to reset
picture and sound adjustments
to the factory preset level.
0
Picture
adjustment buttons
BALANCE control buttons
Press L
to
increase the sound volume ot the left speaker
or R to
increase
the sound volume of
the right speaker.
BASS
control
buttons
Press +
to
increase the bass (low tone)
or
-
to
decrease
it.
TREBLE
control buttons
Press +
to
increase the treble (high tone) or
-
to
decrease it.
SHARP
(sharpness)
control
buttons*
Press + to obtain a sharp picture
or
-
to obtain a less
sharp picture.
BRIGHT (brightness) control buttons
Press +
to
make the picture brighter or
-
to make it
darker.
COLOR control buttons*
Press + to
make the color intensity vivid or
-
to
make it
darker.
HUE control buttons*
Press
G
(green)
to
make the skin tones greenish or R
(red) to make it
purplish.
*
These buttons have no effect on the picture fed through the
RGB
(31
5
kHz) connectors.
5