How to fix Sony Projector when the power is not turned on?
If the Sony Projector's power isn't turning on, there might be a few reasons. If the power was recently turned off and on, wait about 45 seconds before trying again. Also, make sure the lamp cover and the air filter cover are securely closed and attached, respectively.
What to do if Sony VPL-EX4 picture is too dark?
If the picture on your Sony Projector is too dark, first adjust the contrast and brightness settings in the “Adjust Picture...” menu. If the issue persists, the lamp may be burnt out or dim, and you might need to replace it with a new one.
What to do if Sony VPL-EX4 image extends beyond the screen?
If the image on your Sony Projector extends beyond the screen, and there are black edges around the image, display the full image on the screen and press the APA key. Also, check if the input signal frequency is within the projector's acceptable range. If the resolution setting of the computer's output signal is too high, set the output setting to SVGA (VPL-ES4) or XGA (VPL-EX4).
How to fix incorrect color balance on Sony VPL-EX4 Projector?
If the color balance on your Sony Projector is incorrect, start by adjusting the picture settings. If that doesn't resolve the issue, check the “Color System” setting on the SET SETTING menu and ensure it matches the color system being input.
Why does Sony VPL-EX4 say 'Please replace the Lamp'?
The message 'Please replace the Lamp' indicates that the lamp needs to be replaced. When this message appears even after replacing the lamp, the task has not been completed. Perform the operation of steps 8 and 9.
What does it mean when Sony VPL-EX4 says 'Please clean the filter'?
The message 'Please clean the filter' on your Sony Projector indicates that the filter needs cleaning. Clean the filter.
What to do if Sony VPL-EX4 has no picture?
First, ensure all cables are properly connected. This projector supports DDC2B; if your computer is compatible, connect the projector, turn it on, and then start your computer. Also, verify that the correct input source is selected using the INPUT key. Finally, check if the picture is muted and, if so, press the PIC MUTING key to release it.
Why is my Sony Projector picture not clear?
If the picture on your Sony Projector is not clear, try adjusting the focus. If that doesn't work, condensation might have accumulated on the lens. If so, leave the projector on for about two hours to allow the condensation to dissipate.
Why does Sony Projector have no sound?
If there is no sound coming from your Sony Projector, check that all audio cables are properly connected. Ensure you are using a no-resistance stereo audio cable. You may also need to adjust the sound using the VOLUME +/– key on the Remote Commander or the “Volume” setting on the PICTURE SETTING menu.
What does it mean when LAMP/COVER indicator lights up in red, green or orange on Sony VPL-EX4 Projector?
If the LAMP/COVER indicator lights up in red, green, or orange on your Sony Projector, it indicates that the electrical system has broken down. Consult with qualified Sony personnel.
General| Matrix size | 0.63 \ |
|---|---|
| Heat dissipation | 750.7 BTU/h |
| Projection distance | - m |
| Projection technology | LCD |
| Contrast ratio (typical) | - |
| Screen size compatibility | - \ |
| Projector native resolution | XGA (1024x768) |
| Lamp type | UHP |
| Lamp power | 165 W |
| Light source type | Lamp |
| Service life of light source | - h |
| Focal length range | 18.9 - 22.7 mm |
| RS-232 ports | 1 |
| Dimensions (WxDxH) | 308 x 267 x 98 mm |
| Power requirements | AC 100 - 240V, 50/60 Hz |
| Full HD | No |
| Analog signal format system | PAL, SECAM |
| Serial interface type | RS-232 |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| Power consumption (standby) | 5 W |
| Power consumption (typical) | 220 W |
| Storage temperature (T-T) | -20 - 60 °C |
| Operating temperature (T-T) | 0 - 35 °C |
| Storage relative humidity (H-H) | 10 - 90 % |
| Operating relative humidity (H-H) | 35 - 85 % |
| Product color | Black, White |
| Market positioning | Portable |
| Noise level | - dB |
Weight and Dimensions| Weight | 3000 g |
|---|
To Next Page
