How to fix Sony VPL-HS51 when the power is not turned on?
If your Sony Projector isn't turning on, wait about one minute before attempting to turn it on again. Also, make sure that the lamp cover and the air filter cover are securely closed.
Why does the picture from the VIDEO or S VIDEO INPUT connector look strange on my Sony VPL-HS51?
If the picture from the VIDEO or S VIDEO INPUT connector appears colored strangely on your Sony Projector, try adjusting the picture settings in the “Adjust Picture” section of the Picture menu. Also, ensure that the “Color System” setting in the Setup menu matches the color system being input.
Why is the picture from the INPUT A connector colored strange on my Sony Projector?
If the picture from the INPUT A connector is displaying strange colors on your Sony Projector, select the appropriate option (“Computer,” “Component” or “Video GBR”) for “Input-A Signal Sel.” in the Setup menu according to the input signal.
Why is there no picture on my Sony VPL-HS51?
If you're not seeing a picture on your Sony Projector, first, verify that all connections are properly made. Next, make sure you've selected the correct input source using the INPUT button. If you're using a computer, ensure the computer signal is set to output from an external monitor, or only to an external monitor. Also, check the Setup menu and select the appropriate option (“Computer,” “Component” or “Video GBR”) for “Input-A Signal Sel.” based on your input signal.
What to do if the remote control for my Sony VPL-HS51 does not work?
If the remote control for your Sony Projector isn't working, try replacing the batteries with new ones. Ensure that you insert the batteries with the correct polarities.
How to make the picture clearer on my Sony VPL-HS51 Projector?
To improve picture clarity on your Sony Projector, adjust the focus using the focus ring. If that doesn't fully resolve the issue, leave the projector powered on for about two hours.
What does it mean when the LAMP/COVER light is on my Sony Projector?
If the LAMP/COVER light is illuminated on your Sony Projector, it means you should replace the lamp. Alternatively, you can wait until the lamp cools down, and then try turning the power on again.
How to brighten the picture on my Sony Projector?
If the picture on your Sony Projector is too dark, adjust the contrast or brightness in the “Adjust Picture” settings of the Picture menu.
How do I fix 'Frequency is out of range!' on my Sony Projector?
To resolve the 'Frequency is out of range!' message on your Sony Projector, input a signal that falls within the projector's acceptable frequency range. You can also set the output signal on the connected computer's external monitor to SVGA. Additionally, ensure that “Input-A Signal Sel.” in the Setup menu is set to “Computer.”
Why is the LAMP/COVER light flashing on my Sony Projector?
If the LAMP/COVER light is flashing on your Sony Projector, make sure that both the lamp cover and the air filter cover are securely attached.
To Next Page
General
