How to turn on Sony VPL-PX11 Projector if it's not turning on?
If your Sony Projector isn't turning on, it could be due to a few reasons. If you've recently turned the power off and on, wait about 90 seconds before trying again. Also, make sure the lamp cover and the air filter cover are securely closed.
Why is the LAMP/COVER indicator lit on my Sony Projector?
If the LAMP/COVER indicator is lit on your Sony Projector, it means either the lamp has reached the end of its life and needs replacement, or the lamp has reached too high a temperature. In the latter case, wait for 90 seconds to cool down the lamp before turning the power on again.
Why is TEMP/FAN indicator light on Sony VPL-PX11?
If the TEMP/FAN indicator is lit on your Sony Projector, it indicates that the internal temperature is unusually high. Check to ensure that nothing is blocking the ventilation holes.
What does it mean when the LAMP/COVER indicator flashes on Sony VPL-PX11?
If the LAMP/COVER indicator is flashing on your Sony Projector, it means that either the lamp cover or the air filter cover is detached. Make sure to securely attach both covers.
How to adjust color balance on Sony Projector?
If the color balance of the video picture is not correct on your Sony Projector, the color system of the input signal might not be set correctly. Adjust the 'COLOR SYS' setting in the PICTURE CTRL menu to match the color system of the input signal.
What does 'Please replace the LAMP' mean on Sony VPL-PX11 Projector?
If your Sony Projector displays 'Please replace the LAMP', it indicates that it is time to replace the lamp.
How to fix no sound on Sony VPL-PX11?
If there is no sound on your Sony Projector, the most likely cause is a disconnected or improperly connected cable. Check all cable connections to ensure they are properly connected.
What to do if my Sony VPL-PX11 Projector shows 'High temp.! Lamp off in 1 min. Frequency is out of range!'?
This message indicates that the internal temperature of your Sony Projector is too high, and the input signal frequency is outside the projector's acceptable range. Turn off the power immediately. Check the ventilation holes to ensure they are not blocked. Also, ensure that the input signal is within the projector's supported frequency range. If the resolution setting of the output signal of the computer is too high, set the setting of output to XGA.
How to turn on on-screen display on Sony VPL-PX11?
If the on-screen display does not appear on your Sony Projector, check the SET SETTING menu. If 'STATUS' is set to 'OFF', change it to 'ON'.
How to get sound through external monitor on Sony VPL-PX11 Projector?
If you're not getting sound through the external monitor connected to your Sony Projector, check the SET SETTING menu. If 'SPEAKER' is set to 'OFF', set it to 'ON'.
Electrical safety, handling, ventilation, and general warnings for projector operation.
Detailed functions of control panel keys and status indicator lights.
Explains remote buttons, battery installation, and usage notes.
Placement guidelines based on screen size and general connection advice.
Setup for PC/AT and Macintosh, including USB functions.
Powering on, input selection, and how to cut off the picture.
Using APA for optimal image quality and procedures for powering down.
Diagnosing and resolving power and picture display issues.
Addressing audio issues and interpreting error/warning messages.
To Next Page
General
