30
Network Management On: Set when connected to the network and continuously
communicating with the projector control equipment.
When Network Management is set to “On,” the network function is
continuously enabled. Set Network Management to “Off” for normal
use. If you set to “On,” the power consumption increases.
Power Saving Sets the power saving mode.
Standby: If no signal is input for 10 minutes, power is turned off
automatically and the projector goes into standby mode.
Off: Disables the power saving function.
Lamp Setting When replacing the lamps, set the desired lamp setting
(page 47).
All Reset All settings are initialized to their factory preset values.
The “Lamp Timer” in the Information menu is not reset.
Setting items Description
Note
To Next Page
Loading...
