35
Installation Menu
The Installation menu is used for changing the installation settings.
Setting items Description
Image Flip Flips the picture on the screen horizontally and/or vertically.
HV: Flips the picture horizontally and vertically.
H: Flips the picture horizontally.
V: Flips the picture vertically.
Off: The picture does not flip.
Use this item for installation for the backside projection or ceiling
installation.
Lens Control Avoids any operation of the lens such as “Lens Focus,” “Lens Zoom,”
and “Lens Shift,” by mistake.
On: Enables adjustment of the lens.
Off: Prevents any adjustment of the lens.
Anamorphic Lens Select a setting to match the anamorphic lens conversion ratio.
1.24x: Select this when you use an anamorphic lens with a horizontal
rate of 1.24×.
1.32x: Select this when you use an anamorphic lens with a horizontal
rate of 1.32×.
Trigger Select Switches the output function of the TRIGGER connector.
Off: Turns off the TRIGGER connector function.
Power: Outputs a 12 V signal from the TRIGGER connector when the
unit is on. The TRIGGER connector does not output any signals when
the unit is in standby.
V Stretch: Works with the “Aspect” setting’s “V Stretch” (page 28) and
outputs a 12 V signal from the TRIGGER connector.
2.35:1 Zoom: Works with the “Aspect” setting’s “2.35:1 Zoom”
(page 28) and outputs a 12 V signal from the TRIGGER connector.
IR Receiver Selects the remote control detectors (IR Receiver) on the front and rear
of the unit.
Front & Rear: Activates both the front and rear detectors.
Front: Activates the front detector only.
Rear: Activates the rear detector only.
To Next Page
Loading...
Need help?
General
