What to do if my Sony Projector power is not turned on?
If your Sony Projector is not turning on, wait about 1 minute before attempting to turn it on again. Also, ensure that the lamp cover and the filter holder are securely closed and tightened. Check the warning indicators as well.
Why is my Sony Projector picture too dark?
If the picture on your Sony Projector appears too dark, try adjusting the “Contrast” or “Brightness” settings located in the Picture menu. This should help brighten the image to your desired level.
What to do if my Sony VPL-VW90ES Projector is not clear?
If your Sony Projector's picture is not clear, first adjust the focus. If the issue persists, condensation may have accumulated on the lens. Leave the projector on for about 2 hours to allow the condensation to dissipate.
Why is the picture from the INPUT A connector colored strange on my Sony VPL-VW90ES?
If the picture from the INPUT A connector on your Sony Projector appears strangely colored, select the appropriate input signal setting (“Computer,” “Component,” or “Video GBR”) for “Input-A Signal Sel.” in the Setup menu. This setting should match the type of input signal you are using.
Why does the bright area of the picture become unclear on my Sony VPL-VW90ES?
The symptom of unclear bright areas on your Sony Projector might occur if the input signal isn't a standard HDMI signal. Try switching the RGB dynamic range of the connected equipment to Limited (16-235). If this isn't possible, adjust the “Brightness,” “Contrast,” or “Sharpness” settings in the Projector’s Picture menu.
Why is the picture from the VIDEO INPUT connector colored strange on my Sony Projector?
If the picture from the VIDEO INPUT connector on your Sony Projector is showing strange colors, first try adjusting the picture settings in the Picture menu. If that doesn't work, set the “Color System” in the Setup menu to match the color system of the input source.
General| Projection distance | - m |
|---|---|
| Projection technology | SXRD |
| Contrast ratio (typical) | - |
| Screen size compatibility | 40 - 300 \ |
| Projector native resolution | 1080p (1920x1080) |
| RS-232 ports | 1 |
| Dimensions (WxDxH) | 470 x 484.9 x 179.2 mm |
| Connectivity technology | Wired |
| Focus | Manual |
| Zoom capability | Yes |
| Focal length range | 18.5 - 29.6 mm |
| Lamp power | 200 W |
| Lamps quantity | 1 lamp(s) |
| Light source type | Lamp |
| Service life of light source | - h |
| DVI port | No |
| Serial interface type | RS-232 |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| S-Video inputs quantity | 0 |
| Analog signal format system | NTSC 3.58, NTSC 4.43, PAL, PAL M, PAL N, SECAM |
| Product color | Black |
| Market positioning | Home cinema |
| AC input voltage | 100 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (standby) | 0.5 W |
| Power consumption (typical) | 320 W |
| Power consumption (PowerSave) | 8 W |
| Noise level | - dB |
Weight and Dimensions| Depth | 484.9 mm |
|---|---|
| Width | 470 mm |
| Height | 179.2 mm |
| Weight | 12000 g |
To Next Page
