12
Storing station names
— Station Memo
You can assign a name to each radio station and
store it in memory. The name of the station
currently tuned in appears in the display. You can
assign a name using up to 8 characters for a
station.
1 Tune in a station whose name you
want to store.
2 Press (LIST) for 2 seconds.
3 Enter the characters.
1 Press the volume +/– button to
select the desired character.
A y B y C ... y 0 y 1 y 2 ... y
+
y – y
*
... y *
1
y A
*1 (blank space)
2 Press (SEL) after locating the
desired character.
The next character flashes.
3 Repeat steps 1 and 2 to enter the
entire name.
4 To return to normal radio reception
mode, press (LIST) for 2 seconds.
Tip
Simply overwrite or enter “ ” to correct or erase a
name.
Erasing the station name
1 Press (LIST) for 2 seconds.
2 Press (DSPL) for 2 seconds.
The stored names will appear.
3 Press the volume +/– button
repeatedly to select the station name
you want to erase.
4 Press ( SEL ) for 2 seconds.
The name is erased.
Repeat steps 3 to 4 if you want to erase other
names.
5 Press (LIST) for 2 seconds.
The unit returns to normal radio reception
mode.
Note
If you have already erased all of the station names,
“NO DATA” appears in step 4.
Tuning in a station through a
list
— List-up
1 During radio reception, press (LIST)
momentarily.
The frequency or the name assigned to the
current station appears in the display.
2 Press (LIST) repeatedly until you find
the desired station.
If no name is assigned to the selected station,
the frequency appears in the display.
3 Press either side of (SEEK) to tune in
the desired station.
To Next Page
