73
d UTIL (utility) connector (RJ-45, 1000BASE-T
compliant)
Use when controlling serial tally, GPI input/output, or
external device via a network.
e MVS (multi format video switcher) connector
(RJ-45, 1000BASE-T compliant)
Connect to a switcher control station via an Ethernet
switch.
f S-BUS connector (BNC-type)
Connect a cable with BNC connector to an S-Bus data link
via a T bridge.
Connecting devices such as routing switchers and AUX
bus remote panels via an S-Bus data link enables the
following kinds of control.
• Generation and return of tally information on the S-Bus,
based on data received from other devices.
• Switching of cross-points on a routing switcher from the
control panel.
• Switching of cross-points on a switcher from the remote
panel.
• Display of source names configured by a routing
switcher on the control panel.
g REMOTE connectors (D-sub 9-pin, RS-422A
compliant)
MKS-X2700: 1 to 6 connectors
MKS-X7700: 1 to 6 connectors, 1 to 4 connectors
Connect to a device controlled using Sony 9-pin VTR,
VDCP (Video Disk Communications Protocol), Odetics
protocol, or P-Bus (Peripheral II Protocol) protocols.
h SERIAL TALLY 1 and 2 connectors (D-sub 9-pin,
RS-422A compliant)
Outputs tally information generated by the switcher
control station of the XVS system.
i TALLY/GPI OUT connectors (D-sub 37-pin)
MKS-X2700: 1 to 36 connectors
MKS-X7700: 1 to 54 connectors
Outputs tally information generated by the switcher
control station of the XVS system using a relay. It can also
be used as a GPI output port.
The output setting is controlled from the control panel of
the XVS system.
j TALLY/GPI IN connectors (D-sub 37-pin)
MKS-X2700: 1 to 34 connectors
MKS-X7700: 1 to 68 connectors
Input a trigger signal as a GPI input.
The input setting is controlled from the control panel of the
XVS system.
To Next Page
Loading...
