Sony XVS-8000 - Utility;Shotbox Control Block

45
The [GPI ENBL] button function is not supported.
The numeric keypad buttons on the numeric keypad
control block are also used when entering numeric values
in conjunction with other operations, such as setting
parameters using the device control block (trackball), or
keyframe editing and setting the transition rate on the
utility/shotbox control block. While setting an item, the
item and the numeric value appear on the display.
Utility/Shotbox Control Block
You use the utility/shotbox control block for executing
functions assigned to memory recall buttons, editing and
executing keyframe effects, editing macros, and display
the transition rate.
a Mode selection buttons
These buttons select the operation mode of the utility/
shotbox control block. Press a mode selection button to
change the memory recall buttons to the display for the
selected operation mode.
You can change the assignment of mode selection buttons
in the Setup menu.
For details, see “Setting Utility/Shotbox Control Block
Button Assignments” (page 412).
. (period) • Enters the decimal point.
• Enters “00” in timecode input
mode.
• Used for searching for empty
registers in effect operation
mode, snapshot operation mode,
and shotbox operation mode.
+/−
EFF DISS (effect
dissolve)
• Inverts the sign (plus and minus)
• Used to add effect dissolve
attributes in snapshot operation
mode and effect operation mode.
CLR (clear)
AUTO TRANS (auto
transition)
• Clear an entered numeric value.
• Used when adding an auto
transition attribute in snapshot
operation mode.
TRIM
GPI ENBL (GPI
enable)
When entering the difference from
the current value, enter a numeric
value and then press the [TRIM]
button.
Button name Description
ENTER Confirms an entered value or
selected attribute.
Note
Button name Description
b Keyframe control
buttons
c Memory recall
buttons
a Mode selection buttons