Help Guide
Digital Camera
ZV-1M2
ISO (still image/movie)
Sensitivity to light is expressed by the ISO number (recommended exposure index). The larger the number, the higher
the sensitivity.
Menu item details
ISO AUTO:
Sets the ISO sensitivity automatically.
ISO 80 – ISO 12800:
Sets the ISO sensitivity manually. Selecting a larger number increases the ISO sensitivity.
Hint
You can change the range of ISO sensitivity that is set automatically in [ISO AUTO] mode. Select [ISO AUTO] and press the right
side of the control wheel, and set the desired values for [ISO AUTO Maximum] and [ISO AUTO Minimum].
The higher the ISO value, the more noise will appear on the images.
The available ISO settings will differ depending on whether you are shooting still images, shooting movies, or shooting slow-
motion/quick-motion movies.
When shooting movies, ISO values between 125 and 12800 are available. If the ISO value is set to a value smaller than 125, the
setting is automatically switched to 125. When you finish recording the movie, the ISO value returns to the original setting.
The available range for ISO sensitivity varies depending on the setting for [Gamma] under [
Picture Profile].
Note
[
ISO] is set to [ISO AUTO] in the following shooting modes:
[Intelligent Auto]
[Scene Selection]
When the ISO sensitivity is set to a value lower than ISO 125, the range for recordable subject brightness (dynamic range) may
decrease.
When you select [ISO AUTO] with the shooting mode set to [P], [A], [S] or [M], the ISO sensitivity will be automatically adjusted
within the set range.
If you point the camera at an extremely strong light source while shooting images with a low ISO sensitivity, highlighted areas in
the images may be recorded as black areas.
5-049-603-11(1) Copyright 2023 Sony Corporation
ISO on the control wheel → select desired setting.
You can also select MENU →
(Exposure/Color) → [Exposure] → [ ISO].
1
To Next Page
Loading...
