STEP 2
1) Slide both Guiding Tube (05) through Rubber Ring (47) into the 2 holes on the Rear
Stabilizer (3), tighten from the bottom side by X2 Washer (33) and X2 Hex Head Bolt (22).
2) Place the Weight Stack (63) into the Guiding tube (05). (Watch out personal safety)
3) Place the Bushing for Weight Stack (55) onto the Select Bar (12) and fixed by the Fixed
Pin (40). Then place the Weight Stack (62) upper the Select Bar (12) and place the Flat
Washer (36) upper the Weight Stack (62).
4) Insert the Select Pin (32) through the Weight Stack (63) into the hole of Select Bar (12).
9
To Next Page
Loading...
