Flat Ceiling & Plenum Mounting Kit AP6 420(E)/840(E)
What is included in the box
Mounting Instructions
Flat ceiling mount
1. Place the fix-plate to the rear of the Access Point by using the 4 supplied step-screws. Make sure it’s positioned in the right
direction as indicated.
1.
2. Fix the main bracket to a concrete ceiling by using 4 wall anchors and screws or to a ceiling tile by using 4 screws and nuts
(not supplied).
3. Align the Access Point (with fix-plate) via the key holes to the main bracket and push it to the end in the sliding-slot.
2. 3.
Fix-plate (to be fixed to the
rear of the access point)
Screw hole for
product fixing
Spring lock
Main bracket (to be
fixed to the ceiling)
Keyholes
Screw holes for
ceiling mount
Springs
4x M3 step screws
Plenum mount clip plus 2x M4
screws and nuts
(not needed for ceiling mount)
To Next Page
Need help?
General
