29AP6 420(E)/840(E)
Operating Instructions
Flat ceiling mount
To mount your access point to a flat ceiling, please use the “flat ceiling & plenum
mounting kit” which is available as an option from your Sophos partner.
The kit consists of the following components:
Mounting instructions
1. Place the fix-plate on the rear of the Access Point. Make sure
it’s positioned in the right direction as indicated.
2. Install 4 step-screws (M3) from the supply into the bracket holes.
3. Fix the main bracket to a concrete ceiling by using 4 wall anchors and
screws or to a ceiling tile by using 4 screws and nuts (not supplied).
4. Align the Access Point (with fix-plate) via the key holes to the
main bracket and push it to the end in the sliding-slot.
Main bracket (to be fixed to the ceiling)
Keyholes
Screw holes for
ceiling mount
Springs
4x M3 strep screws
Plenum mount clip plus 2x M4
screws and nuts
(not needed for ceiling mount)
Fix-plate (to be fixed to the rear of the access point)
Screw hole for
product fixing
Spring lock
To Next Page
Loading...
