4
2. Mount and Power Up the Switch
Mount the switch in the rack
If you want to mount the switch in a rack, please use the supplied rackmount kit for this device where
available. For instructions on how to mount your switch, please see the Operating Instructions under
www.sophos.com/get-started-switch
Connect the power cable and turn on the switch
Connect the power supply (where available) and/or supplied power cable to the switch and turn it on (if
unit has a power button). After a few seconds, the Power LED will start blinking and the switch will boot.
This process should take just a few minutes. After the boot-up is complete the Power LED will turn to
solid green.
Connect Grounding Cable (CS101-8x models only)
If ethernet cables are run between buildings or if the switch is used in a high lightning exposure area,
connect a safety ground wire to the grounding screw to provide additional protection from electrical
shock. If unsure of your electrical ground, consult an electrician.
Internet
e.g., DSL modem
Firewall
Switch
ENGLISH
Quick Start Guide Sophos Switch Series
To Next Page
Loading...
Need help?
General
