Radiation intensity
If the radiation intensity set here is exceeded in watts see " Starting aid " on page 28see "Starting aid function" on page 1
Blocking time
Here a blocking time in minutes can be defined. Within this the starting aid function is disabled.
Daylight saving time
If this function is activated, the controller automatically changes to winter time or summer time (DST, Daylight Savings Time).
Eco Display Mode
In Eco Display Mode the backlight of the display is switched off if no buttons are pushed for 2 minutes.
If a message exists, the backlight does not switch off until the message has been scanned by the user.
Temperature unit
In this menu, you can select which temperature unit is displayed.
Network
If applicable, the network settings of the connected data logger have to be adjusted
Access Control
This menu lets you give up to 4 users access to the data logger. The users that are registered then have access to the controller
or respectively the data logger.
To
ad
d
a
use
r
in
the
l
ist,
se
le
ct
<a
dd
u
se
r>.
L
ea
ve
the
n
ow
vi
si
b
le
me
n
u
op
e
n
un
d
co
nn
e
ct
to
t
h
e
a
dd
re
ss
o
f
the
co
n
ne
ctor
or
respectively the data logger. Your user name is going to appear in this menu and can be selected and confirmed with ‘OK’.
Note
You can find the address of the connector or respectively the data logger on the address sticker on the outside of the casing.
Pointers and help on how to establish a connection you can find in the enclosed SOREL connect instructions or the instructions
of the data logger.
Select a user with ‘OK’ to grant access.
To revoke access again, choose one of the users from your list and choose <remove user>.
Ethernet
The data logger‘s Ethernet connection settings can be set using this menu.
MAC Address
Displays the individual MAC address of the data logger.
Auto-Configuration (DHCP)
If auto-configuration is activated, the data logger requests IP addresses and network parameters from a DHCP server that
assigns an IP address, subnet mask, gateway IP and DNS server IP. If you deactivate the auto configuration (DCHP), you will
have to make the required network settings manually!
IP-Address
Please refer to the router configuration for the IP address to be set.
Subnetz
Please refer to the router configuration for the subnetz to be set.
Gateway
Please refer to the router configuration for the gateway to be set.
DNS-Server
Please refer to the router configuration for the DNS server to be set.
CAN bus ID
Here you can see the ID of the controller on the CAN bus.
29
To Next Page
Loading...
