22
Menu “3. Display mode” is used to defi ne
the controller’s display for normal opera-
tion. This display appears whenever two
minutes go by without any key being
pressed. The main menu appears again
when a key is pressed. The menu is
closed by pressing “esc” or selecting “Exit
display mode”.
3.1 Schematic
In graphics mode, the selected hydraulic systems are depicted with the measured
temperatures and operating states of the connected consumers.
3.2 Overview
In overview mode, the measured temperatures and operating states of the connected consum-
ers are depicted in text form.
3.3 Alternating
In alternating mode the schematic mode and then the overview mode are active for 5
seconds at a time.
Display mode
3. Display mode
3.4 Eco Mode
Eco mode switches the backlight of the display off after 2 minutes.
Default: Off
To Next Page
