Sorenson ntouch VP2 User Manual

QuickHelp Sorenson ntouch VP2
Calling Features
Use the bookmarks in the left-hand column to jump to the QuickHelp answers to these questions:
How do I use the Group Call feature?
How do I set up Voice Carry Over (VCO) calling?
How do I show the in-call audio level meter?
How do I change how long the options bar appears when a call starts?
How do I change my Self-View image video settings during a call?
How do turn the Do Not Disturb mode on and off?
How do I use the Group Call feature?
You can use the Group Call feature to have a conversation with up 4 other people at one
time. A group call begins when you “join” two calls together into one call. You can then
add up to 2 other calls (for a total of 4 calls) at once. You can use the ntouch VP2 Group
Call feature with all Sorenson endpoints during a point-to-point call. The Group Call
feature does not work with Sorenson Video Relay Service (SVRS) calls.
The example images below show the Video Privacy mode enabled on all endpoints. This
was done to make it easier to see how to use the feature.
Step 1. When in an active call, press the OK key on the remote control to open the In-call
options bar as shown below.
Step 2. Move to the Call button as shown below.
In-call options bar
Call button

Sorenson ntouch VP2 Specifications

General

Category	Telephone
Type	Video Phone
Video Resolution	720p
Video Compression	H.264
Audio Codec	G.711, G.722, G.729
Camera	Built-in HD camera
Connectivity	Ethernet, WiFi
WiFi	802.11 b/g/n
HDMI Output	Yes
Ethernet	10/100 Mbps
Compatibility	SIP
Power	AC adapter

Summary

How do I use the Group Call feature?

Using the Group Call Feature

Step-by-step guide to initiating and managing group calls, allowing conversations with up to four people.

How do I set up Voice Carry Over (VCO) calling?

Setting up Voice Carry Over (VCO) Calling

Detailed instructions for enabling and configuring 1-line or 2-line Voice Carry Over (VCO) for enhanced calling.

How do I show the in-call audio level meter?

Displaying the In-Call Audio Level Meter

Enabling the audio meter feature, which provides visual feedback on call audio levels during active calls.

How do I change how long the options bar appears when a call starts?

Adjusting In-Call Options Bar Display Time

Customizing the duration the in-call options bar remains visible after a call begins for user convenience.

How do I change my Self-View image video settings during a call?

Modifying Self-View Video Settings During a Call

Instructions on how to adjust video settings like zoom, pan, focus, brightness, and saturation for the self-view image.

How do turn the Do Not Disturb mode on and off?

Managing Do Not Disturb Mode

Procedure to activate and deactivate the Do Not Disturb mode, redirecting incoming calls to SignMail.