1. Safety instructions for users
These instructions contain the necessary information for the correct use of
the products described. They are for use by technically qualified persons.
Qualified personnel are those persons whose vocational training, experience
and internal training and their knowledge of the relevant standards, regu-
lations, accident prevention regulations and plant operating conditions has
led the person responsible for operational safety to authorise them to car-
ry out the necessary work, and are able to recognise and avoid potential
risks (definition of skilled workers as per IEC 364).
Risk information
The following information serves not only the personal safety of the oper-
ating personnel but also the safety of the products described herein and
appliances connected to them.
High-voltage operations.
Non-compliance can lead to death, serious injury or damage to property.
-
-
-
-
-
-
Always disconnect the supply voltage before assembly or dismantling
work, when replacing fuses or altering the structure.
The relevant Accident Prevention and Safety at Work Regulations must be
complied with at all times.
Before commissioning, make sure that the appliance's nominal voltage
conforms to the local mains voltage.
EMERGENCY SWITCHES must remain operational in all working modes. Unlock-
ing EMERGENCY SWITCHES must not lead to uncontrolled.
Electrical connections must be covered at all times!
After assembly, check all protective conductor systems for correct func-
tioning!
Proper use
The appliance described here is an electrical device for use in feeder
equipment or automation plant.
The appliance has been planned for use in oscillation conveyors, in control
and automation technology.
To Next Page
Loading...