To Next PageTo Next Page
Need help?Do you have a question about the SoundCraft POWERSTATION 600 and is the answer not in the manual?
General| Brand | SoundCraft |
|---|---|
| Model | POWERSTATION 600 |
| Category | Music Mixer |
| Language | English |
Details the XLR microphone input, impedance, and phantom power.
Explains the high-impedance TRS line input for keyboards, synths, etc.
Describes the pre-EQ insert point for external signal processing.
How to set input gain for optimal signal level and headroom.
Function of the 100Hz filter to reduce low-frequency rumble.
Details HF, MID, and LF EQ knobs for tone shaping.
Pre- and post-fade sends for monitors and effects.
Routes channel signal to the internal Lexicon effects processor.
Adjusts the channel's position in the stereo image.
Enables pre-fader listening to individual channels via headphones.
Controls the output level of the individual channel fader.
Description of dual inputs for stereo sources and mono use.
Adjusting input level for various professional and hi-fi sources.
HF, MID, and LF EQ controls for tone shaping stereo signals.
Pre- and post-fade sends for monitors and effects from stereo channels.
Sends stereo channel signal to the Lexicon FX bus.
Controls stereo image placement for stereo channels.
Pre-fader listening for stereo channels.
Controls the output level for stereo channels.
Controls the overall volume of the master effect send.
Sets the final output level for the main stereo mix.
Configures Aux Send 2 for pre-fade operation.
Mixes Lexicon FX output into the Aux 1 send.
Sets the final level for the Aux 1 mix output.
Sets the final level for the Aux 2 mix output.
Handles inputs from external stereo effects units.
Inputs for external sources like interval music.
Pre-fader listening for the 2 Track Return signal.
Routes the 2 Track Return to the main stereo mix.
Adjusts the signal level sent to monitor headphones.
Indicates when PFL is active for channel monitoring.
Adjusts the input level to the integral effects processor.
Selects and fine-tunes built-in effects programs.
Details the 7-band stereo graphic equalizer for tonal adjustments.
Allows bypassing individual EQ channels for comparison.
Provides phantom power for condenser microphones.
Explains the POWER, THERMAL, and MUTE status lights.
Sets the output level sent to the integral stereo power amplifier.
Illustrates flexible audio signal routing using the patchbay.
Steps for setting initial control positions for first-time use.
Lists common problems and provides solutions for the mixer.
Illustrates typical initial control settings on the mixer console.
Provides physical dimensions and rack mounting details for the unit.
Lists key technical specifications like THD, noise, and output levels.
