STORE
Pressing this button will create a snapshot at the end of the Cue list.
RECALL
Pressing this will cause the console’s controls to be set according to the infor-
mation recalled from the highlighted cue in the cue list. The highlighted cue is
adjusted using the ADJUST encoder.
NEXT
Pressing this will recall the information from the next cue in the cue list.
PREVIEW MODE
This function is not yet implemented.
ISOLATING INDIVIDUAL CHANNELS AND BUSES
FROM RECALL
Individual Channels and Buses can be stopped from receiving recalled data by using the ISOLATE function.
For channels, the isolate button is located in the channel function buttons group. Pressing this button will
isolate the channel whose SEL button is active. It doesn’t matter if the input bay is in Channel Mode or
Global Mode.
For output buses, the isolate control is located via the OUTPUT PROCESSING button in the BOTH ROWS sec-
tion. The isolate button is below the fourth soft button from the left of the top row of encoders. Pressing this
will isolate the bus whose SEL button is active.
To Next Page
Loading...
Need help?
General
