Need help?Do you have a question about the SoundCraft Si3 and is the answer not in the manual?
General| Type | Digital Mixer |
|---|---|
| Channels | 32 |
| Outputs | 16 |
| EQ | 4-band parametric EQ |
| Groups | 8 |
| Matrix Outs | 8 |
| Main Outs | 2 |
| USB Audio Interface | Yes |
| Word Clock | Yes |
| Dynamic Processing | Compressor and gate per channel |
| Digital I/O | ADAT |
Step-by-step guide on how to power on the console using the POWER ON button.
Crucial procedure for safely powering down the console to prevent display damage.
Explanation of how to select input layers for controlling different channel groups via faders.
Details on selecting functions for output faders (bus outputs, matrix, VCA groups).
Describes signal level metering on OLED screens above channel faders.
Describes signal level metering on the 12-segment bar graph meters.
Controls channel's signal routing to Main Mix or Group/Aux buses.
Routes channel signal to solo bus for monitoring in PFL, AFL, or SIP modes.
Defines VCS display modes: DYN, EQ, BUS 1-12, BUS 13-24, AUX PRE for parameter control and routing.
Encoders control Gain, Filters/Delay, Gate, Compressor, EQ, and Pan for input channels.
Buttons (BUS 1-8, 9-16, 17-24) act as 'jumping in' points for aux/group output bus feeds.
Buttons for 48V, Phase, Delay, Filters, Gate In, Comp In, EQ In, Insert In, LR, C, LCR, Isolate.
Right-hand encoder on input bay is reserved for Pan control.
Input bay encoders act as Pan controls for their own channels in Global Mode.
Procedure to toggle Pan encoder to Width mode for mono inputs routed to LCR.
Selects output faders for bus outputs 1-12.
Selects output faders for bus outputs 13-24.
Selects output faders for Matrix Outputs 1-8 and L/R/C busses.
Selects output faders for VCA groups 1-12.
Displays parameter name/value and selected channel ID depending on UPPER ROW selection.
Displays parameter name/value and selected channel ID depending on LOWER ROW/OUTPUT FADERS SELECT.
Upper row encoders function as EQ for selected input channels.
Upper row encoders function as EQ for selected output channels.
Upper row encoders control parameters for onboard Lexicon effects processors.
To Next Page