SoundCraft Si3 User Manual

Page 2 - 7Soundcraft® Si3 User Guide
CHANNEL AND BUS NAMES
An out-of-the-box console will have the following channel names and bus names. If they are subsequently
edited, the user may return to these default names by performing a factory reset.
Note: pressing the ‘ALT FUNCTION’ button will display the ident of the physical rear panel connector XLR that
is associated with the input channels. This label cannot be deleted.
Channel Names
The default channel names tell the user which mic/line input connector is patched to each fader number. The
names are in the format CHnn-cmm, where nn is the channel fader number 01 to 64, c is the connector bay
(A - D) on the rear connector panel, and mm is the mic/line input connector number (1-16) on that connector
bay.
Examples.
CH01-A01 shows that the Channel 1 fader is patched to mic/line number 1 on rearcon bay A.
CH16-A16 shows that the Channel 16 fader is patched to mic/line number 16 on rearcon bay A.
CH17-B01 shows that the Channel 17 fader is patched to mic/line number 1 on rearcon bay B.
Output Bus Names
The default bus names tell the user which output connector is patched to each output bus. The names are in
the format BSnn, where nn is the bus number 01 to 24,
Matrix Output Names
The default matrix output names tell the user which output connector is patched to each matrix output bus.
The names are in the format MXnn, where nn is the bus number 01 to 24.

SoundCraft Si3 Specifications

General

Type	Digital Mixer
Channels	32
Outputs	16
EQ	4-band parametric EQ
Groups	8
Matrix Outs	8
Main Outs	2
USB Audio Interface	Yes
Word Clock	Yes
Dynamic Processing	Compressor and gate per channel
Digital I/O	ADAT