MCD1820 / English Instruction Manual
3
BASIC OPERATIONS
POWER ON / OFF
Press “ON / STANDBY” to turn the unit on.
Press the button again to turn off the unit in standby mode.
SELECTING MODES
During playing mode, press repeatedly the “FUNCTION” button to switch between the modes.
ADJUSTING VOLUME
Adjust with “Volume + / -” the desired volume.
DAB
1. Press “FUNCTION” button to select “DAB” mode. At first selection the unit start to fully scan
of the DAB channel from 5A to 13F.
2. Tune to the required DAB channel by pressing the “ TUNE -“ or “ TUNE +” button step
by step.
Note:
➢ If there is no DAB+ reception at any time, change the position of the unit or adjust the
antenna. Press “SCAN” button on the remote control to start a new search.
➢ If DAB reception is poor, dropouts may occur or the sound will be muted. Change the
position to improve the reception.
DAB INFORMATION
Press repeatedly “DELETE / INFO” on the remote control to cycle through the DAB information.
STORE PRESET STATION
You can store up to total of 10 DAB radio stations in the memory.
1. In DAB mode, choose the desired radio station. Press and hold “MEM / MENU”, “Empty P1”
will show on the display. Press the “ TUNE -“ or “ TUNE +” to choose the desired
station number.
2. Press the “ / ENTER” button to confirm and ‘Preset 1 Stored’ will show on the display.
3. Repeat the above 1 - 2 steps to store further stations.
RECALL PRESET STATIONS
Press the “FOLDER / PRESET” button on the unit to select preset stations forward and the
“ / ENTER” button to choose the stored station.
You can also press “FOLDER PRESET ” or “FOLDER PRESET ” on the remote control to
select the stored station.
You can overwrite a present station by storing another radio station in its place.
DAB MENU
The device must be in DAB mode. Enter the DAB menu by pressing the “MEM / MENU” button.
Select with “ TUNE –“ or “ TUNE +” the one of the following settings and confirm with
“ / ENTER”:
To Next Page
Loading...
