SOUNDMASTER PL585 User Manual

This symbol indicates the presence of dangerous
voltage inside the enclosure, sufficient enough to
cause electric shock.
This symbol indicates the presence of important
operating and maintenance instructions for the
device.
Safety, Environmental and Setup Instructions
• Use the device in dry indoor environments only.
• Protect the device from humidity.
• Do not open the device. RISK OF ELECTRIC SHOCK! Refer opening and servicing to qualified personnel.
• Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with
the specifications on the rating plate.
• Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.
• A damaged mains cable or plug must immediately be replaced by an authorized service center.
• In case of lightning, immediately disconnect the device from the mains supply.
• Children should be supervised by parents when using the device.
• Clean the device with a dry cloth only.
Do NOT use CLEANING AGENTS or ABRASIVE CLOTHS!
• Do not expose the device to direct sunlight or other heat sources.
• Install the device at a location with sufficient ventilation in order to prevent heat accumulation.
• Do not cover the ventilation openings!
• Install the device at a safe and vibration-free location.
• Install the device as far away as possible from computers and microwave units; otherwise radio reception may be
disturbed.
• Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized
service/ customer center.
• Only use mercury and cadmium-free batteries.
• Used batteries are hazardous waste and NOT to be disposed of with the household waste!!!
Return the batteries to your dealer or to collection points in your community.
• Keep batteries away from children. Children might swallow batteries.
Contact a physician immediately if a battery was swallowed.
• Check your batteries regularly to avoid battery leakage.
• Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
• CAUTION: Danger of explosion if battery is incorrectly replaced
Replace only with the same or equivalent type
ENVIRONMENTAL PROTEC
TION
Do not dispose of this product with the normal household waste at the end
of its life cycle. Return it to a collection point for the recycling of electrical
and electronic devices. This is indicated by the symbol on the product,
user manual or packaging.
The materials are reusable according to their markings. By reusing, recycling or
other forms of utilization of old devices you make an important contribution to
the protection of our environment.
Please contact your local authorities for details about collection points.
WARNING
Risk of electric shock
Do not open
!
Caution: To reduce the risk of electric shock, do not remove the
cover (or back). There are no user serviceable parts inside. Refer
servicing to qualified service personnel.

SOUNDMASTER PL585 Specifications

Power

power supply	AC230V~50Hz
power consumption	20W
output power	2 x 2.5W RMS

Frequency Range

FM frequency range	87.5 – 108 MHz
DAB+ Band III frequency range	174 – 240 MHz

Summary

Environmental Protection and Safety

Warning Symbols Explained

Explains symbols for dangerous voltage and operating instructions, advising caution.

Battery Disposal and Handling

Guidelines for disposing of and handling used batteries responsibly.

Remote Control

Button Functions

Explains the function of each button on the remote control for system interaction.

Battery Installation

Provides step-by-step instructions for installing batteries into the remote control.

Locations of Controls

Device Overview

Identifies and labels the various controls and ports on the main unit.

Connecting to Power

Power Connection Precautions

Advises on necessary precautions before connecting the unit to a power source.

Initial Setup Guide

Guides the user through the initial setup process after connecting to power.

Setting the Clock

Radio Tuning and Reception

FM Tuning Methods

Guides manual and automatic tuning for FM radio stations.

RDS Information Display

Describes how to view broadcast information via the RDS feature.

DAB Tuning and Information

Instructions for digital radio tuning and information display.

Radio Presets and Reception

Storing and Recalling Preset Stations

How to save and retrieve favorite radio stations.

Phono Operations

Playing Records

Instructions for setting up and playing vinyl records on the turntable.

Aux-In Connection

USB Media Playback

Connecting and Initial Playback

How to connect USB devices and start MP3 playback.

Playback Controls

Details on pause, stop, skip, folder navigation, and ID3 tag display.

Playback Modes

Explains different playback modes like repeat and random.

Programming and Encoding

Track Programming

How to program a sequence of up to 20 tracks for playback.

Encoding to MP3

Steps for encoding Phono, Aux-in, DAB/FM sources to USB.

Track Separation During Encoding

How to divide recordings into separate tracks during the encoding process.

USB File Management

Deleting Files from USB

Instructions for deleting single files or all files from a USB drive.

Additional Features

Sleep Timer Setting

How to set a sleep timer for automatic shutdown.

Alarm Clock Function

Setting up the alarm clock to wake the user with music or radio.

Device Functions

Timer and Alarm Settings

How to activate/deactivate the timer and alarm functions.

Audio Settings and Reset

Using preset equalizers, connecting audio, and factory reset.

Technical Specifications

Importer Information