SOUNDMASTER PL585 - Setting the Clock; Radio Tuning and Reception; FM Tuning Methods; RDS Information Display

PL585 / English Instruction Manual
3
SETTING THE CLOCK
1. Set unit in standby mode.
2. Press the “MEM / CLK-ADJ ” button (3) once, the display will start flashing. Press Skip/Tuning or button
(1) to select the appropriate area hour format(12hr/24hr)
3. Press “MEM / CLK-ADJ ” button (3) again, the first second digit of “0” is flashing. Press or button (1) to
set the correct hour. Press ”MEM / CLK-ADJ ” button (3) to store the correct hour.
4. The third fourth digit of “00” is flashing, press the or button (1) to set the correct minutes. Then press
“MEM / CLK-ADJ” button (3) to store the correct minute.
 The clock setting mode will automatically quit if no button is being pressed in a period of about 10
seconds after pressing the “ MEM / CLK-ADJ ” button.
 The set time will be re-set completely if dis-connecting the main power supply. You are recommended
to switch the system into standby mode for convenience usage.
LISTENING TO RADIO – FM
Manual tuning
1. Plug in the provided DAB/FM tuner antenna to the antenna socket (22) then switch on the unit by “On/Standby”
button (13), then turn the “FUNCTION” knob (5) to select “ FM ” mode.
2. Tune to the required station by or tuning button (1).
3. Turn the Volume knob (13) to the desired volume level.
1
Auto tuning
1. Set the unit to FM mode.
2. Press the “SCAN” button (10) once, unit will start to scan at tuning up direct until radio station received. Press
and hold the “SCAN” button (10) for a second, the unit will scan to tuning down direction. If the radio data
system (RDS) broadcasting signal received, the unit will set the actual time automatically.
3. Turn the Volume knob (13) to the desired volume level.
Radio data system (RDS)
This is the features to display the information which released from the radio broadcast and will showed on LCD
display step by step as below by pressing the “Info” button (on the remote control) continuously.
Radio text program type signal strength date/time frequency mono/stereo.
LISTENING TO RADIO – DAB
Digital audio broadcasting (DAB) radio
1. Set the unit to “DAB” mode by Function Knob (5).
2. Press and hold the “SCAN” (10) button for about 2 seconds, unit will start to full scan for searching stations.
Then press tuning or button (1) to select your desired DAB channel.
3. Press the “INFO” button continuously to check the below info released by DAB.
Group name frequency  transfer rate signal strength date/time program type  scrolling text
4. Turn the Volume knob (13) to the desired volume level.
Manual Tuning
1. Set the unit to “DAB” mode by Function Knob (5).
2. Press and hold the “Stop /ENTER” button“ (2),the LCD display will show “Manual tune“.
3. Press “Skip/Tuning or button“ (1) to select the DAB district band (5A – 13F) for your area, and then
press “Stop /ENTER” button“ (2) to confirm.
4. Press “Skip/Tuning or button“ (1) to select the DAB radio station
5. To exit the manual tuning, press the “Stop /ENTER” button“ (2) once.