UR620 / English Instruction Manual
3
SETTING THE CLOCK
Plug in the UR620, but leave the power “OFF”.
Press and hold the “TIME SET” button (13) until the clock flashes in the display.
Press the “TUNE DOWN / HOUR” button (6) repeatedly to set the hour, and press the
“TUNE UP / MIN” button (8) repeatedly to set the minute.
Press the “TIME SET” button (13) again to store the new clock setting.
NOTES: If you do not press any button for about 10 seconds while setting the clock, the clock
setting will be canceled.
SETTING THE ALARM
In standby mode, press and hold the “ALARM” button (10) and the display will begin flashing.
Press the “TUNE DOWN/HOUR” or “TUNE UP/MIN” button (6 or 8) to set the desired alarm time.
Press “ALARM” button (10) to confirm the alarm time set.
The amber LED of alarm source indicator (default as alarm radio) will blink.
Press “TUNE DOWN HOUR” or “TUNE UP / MIN” button (6 or 8) to set the desired alarm source
(Buzzer or Radio). Amber LED of the selected alarm source indicator will light up
Press “ALARM” button (10) to confirm the alarm source set, the volume level will blink on the
display (there is no volume setting if alarm source is set to Buzzer).
Press “TUNE DOWN / HOUR” or “TUNE UP / MIN” button to set the maximum alarm volume.
Press “ALARM” button (10) to confirm the alarm set.
To silence the alarm, press “ALARM” or “POWER ON / OFF” button (10 or 1).
NOTES: To deactivate the alarm, press “ALARM” button (10), the amber LED of alarm source
indicator will turn off. Before setting the alarm, make sure that the clock time is set correctly (see
setting the clock).
SNOOZE
When alarm sounds, pressing the “SNOOZE/ BRIGHTNESS” button (11) will temporarily silence
the alarm. The alarm will sound again after approximately 10 minutes.
To extend the snooze duration, repeatedly press the “SNOOZE / BRIGHTNESS” button (11) to
cycle through and select one of the snooze presets.
NOTE: Once the snooze function has been activated, press the “SNOOZE / BRIGHTNESS”
button (11) anytime and the display will show the remaining time. Repeatedly press the
“SNOOZE / BRIGHTNESS” button (11) to adjust or modify the current snooze time setting.
To Next Page
Loading...
