UR620 / English Instruction Manual
4
SLEEP TIMER
The UR620 features a sleep timer to allow you to fall asleep while listening to the unit.
After the preset time duration ends, the unit will automatically shut off.
When the unit powered ON, press the “SLEEP” button (12). The amber LED of “SLEEP” indicator
will light up and “15” will appear on the display briefly indicating the unit will turn off after 15
minutes.
To increase the sleep time duration, up to a maximum of 90 minutes, repeatedly press the
“SLEEP” button (12) to select one of the following sleep time presets.
With the sleep timer active, press the “SLEEP” button (12) once to view the remaining sleep time.
To cancel the sleep timer function, repeatedly press the “SLEEP” button (12) until “OFF” appears
in the display.
SETTING THE BRIGHTNESS
There are three levels of display brightness available (the default setting is low). Press the
“SNOOZE / BRIGHTNESS” button (11) to cycle through and select the desired setting
NOTE: Make sure that the unit is not in alarm sound status.
STREAMING AUDIO WITH BLUETOOTH
®
WIRELESS
You can stream audio wirelessly to Clock Radio from up to 33’ away using your smartphone
tablet, laptop or other A2DP Bluetooth
®
enabled device.
Turn on the unit by pressing the “POWER ON/OFF” button (1).
Then press the “SOURCE” or “BLUETOOTH PAIR” button (2 or 14). The Bluetooth
®
LED
indicator will flash.
Turn on your Bluetooth
®
enabled device and search for and select “UR620”.
If asked for a password, enter “0000”.
The Bluetooth
®
LED indicator will change from flashing to solid, indicating that your Bluetooth
®
device is now connected to UR620.
Press and hold the “BLUETOOTH PAIR” button (14) for 3 seconds to disconnect the Bluetooth
®
connection.
NOTES: If the last paired Bluetooth
®
audio device is powered on and within range of the
speaker, the device will automatically reconnect to UR620. For the best audio performance, turn
the volume all the way up on your Bluetooth
®
device.
If the unit fails to pair with your Bluetooth
®
device, go to your Bluetooth
®
setting menu, then
select 'UR620 "Info". For Android device, select "Unpair", if using an Apple OS device, select
"Forget this Device". When UR620 appears in your list of Bluetooth
®
devices, select it to
complete pairing.
UR620 can only play audio from one source at a time. If UR620 is connected to a Line-In source,
the Bluetooth
®
will not function. Simply unplug the 3.5mm Line-In audio cable and press the
“SOURCE” or “BLUETOOTH PAIR” button (2 or 14) to switch to Bluetooth
®
.
To Next Page
Loading...
