Soundstream REFERENCE 300SX - Page 3

l o.0
I
l eoeo
d
0 0 0
““.a000
0000
i 123
/- 0
0
\
.
0
0
/
SOTlOM VJEW (PARUALJ
I
I
/ :
1.
2.
3.
4.
5.
6.
7.
0.
9.
Kev to Caiiouts
Fault LED - Indicates a blown fuse.
High Power LED - Indicates amplifier power on in “High Power’
mode.
High Current LED - Indicates amplifier power on in “High Current”
mode.
+12V - Connect to a fuse or circuit breaker, then to the batfery’s
positive post.
GND - Main ground connection. Bolt to a clean chassis ground in
the vehicle.
REM - Remote turn-on input from the head unit. Accepts +lZV.
Speaker Output Connections - Left and right channels.
Input Level - independent Left and Right channel input level
controls.
Inputs - Right and left channel RCA (Differential Balanced ) inputs;
only right channel input is used in “Mono” mode.
IO. Main Fuse-Main power supply fuse. Heplace only with the same
value fuse.
11. Crossover S.1.P.s -Crossover frequency settings for the amplifier.
See page 9 for more details.
12. Amplifier Crossover - Select high pass, low pass or full range
amplifier operation.
13. Mixed Mono/Stereo/Bridge - Select “Bridge” for bridged mono
operation (use right channel input). Select “Stereo” for coherent
stereo operation. Select “Mixed Mono’ for simultaneous stereo I
bridged mono operation.
14. High Power I High Current Switch - Use HIGH CURRENT for
loads at or below 1 ohm stereo (2 ohms mono).
CAUTION: DO
NOT SWITCH WHEN AMPLIFIER IS TURNED ON.
4
5