Why is there no sound and no LEDs on my Soundstream Amplifier?
If your Soundstream Amplifier has no sound and the LEDs aren't lit, check the power and ground connections to ensure they are properly connected. Also, verify the remote turn-on connection is secure. Finally, inspect the fuse near the battery and replace it if it's blown.
What to do if Soundstream Reference CLASS-A-3.0 fuse keeps blowing?
If the Soundstream Amplifier's fuse blows repeatedly or the Smart Power Supply Circuit activates frequently, several factors could be at play. First, ensure your speaker configuration is correct and that the amplifier isn't accidentally set to 'High Power' mode when it should be in 'High Current' mode, especially if your speaker load is less than 1 ohm. You should also check all speaker and lead connections for shorts. Finally, make sure the amplifier has adequate ventilation.
What to do if the Fault LED is lit on my Soundstream Amplifier?
If the Fault LED on your Soundstream Amplifier is lit, the 9 amp power supply fuse may be blown or missing. Replace or install the fuse to resolve this issue.
Guides on selecting appropriate wire gauge for power and ground connections.
Specifies fuse values for amplifier and battery protection.
General| Bridged RMS Power @ 4 Ohms | 100 Watts x 1 |
|---|---|
| THD at Rated Power | 0.02% |
| Bass Boost | 0~18dB |
| Frequency Response | 10Hz |
| Total Harmonic Distortion | 0.02% |
| Crossover Type | LP/HP |
To Next Page