Source Audio Ultrawave - Page 16

Table of Contents Ultrawave Multiband Processor User Guide
16
Stereo In, Stereo Out
This mode should be your default selection for Stereo In, Stereo Out applications. Stereo In, Stereo
Out allows you to continue your stereo chain of effects. When Ch. 1 and Ch. 2 are linked, the
processing will be the same for both channels. When they are unlinked, you can configure separate
settings for Channel 2.
Stereo In, Mono Out
This mode will accept stereo input on jacks INPUT 1 and 2. Inputs 1 and 2 are sent to Channel 1 and 2
respectively. When Ch. 1 and Ch. 2 are linked, the processing will be the same for both channels.
When they are unlinked, you can configure separate settings for Channel 2. The outputs of the
Channel 1 and Channel 2 equalizers are mixed together and sent to OUTPUT 1.