Leveling-2
15
About 0.2mm，like the thickness of a piece
of A4 paper. When you drag the paper
between the nozzle and the hotbed, if the
nozzle can scratch on the paper slightly,
that means the distance between the nozzle
and the hotbed is suitable.
+
-
0.2mm
Leveling
Remember to click “Save” after leveling.
0.00
Step value
Operating
nozzle ascends
Z offset value
Operating
nozzle descends
Save
After the machine stops, adjust the Z offset value in
order to adjust the distance between nozzle and hot bed.
To Next Page
Loading...
