Leveling-1
14
Leveling
a b
c
I t i s q u it e n o r m a l , i f n o i s e
produces after the machine hits
the top. Please wait patiently
until it goes down.
This step is not required for
l e v e li n g p e r ti me b u t i t i s
required when the whole X-axis
is not horizontal enough.
Click the “Leveling” on the main interface, the machine will
auto home first. After the machine stops, click “Auto Z-axis
Alignment”, and the whole X-axis beam of the machine will
ascend to the top and then descend to zero again.
To Next Page
Loading...
