Click the temperature icon → select preheat PLA/ABS on the
main interface.
When the temperature reaches the target value, cut the front
end of filament at a 45° bevel and insert it into the feed port for
about 20mm. Hold it downward with your hand and turn the
wheel in a clockwise direction until filament could be seen
extruding out of the nozzle.
17
Unlock motor, if there is
certain resistance and
difficult to turn when turning
the wheel,please unlock the
motor.
Steps for motor unlocking:
Main interface → “Move axis”
→ “Unlock Motor”.
Axis of
movement
Unlock motor
Load filament
To Next Page
Loading...
