• Do not touch the device or the power adapter with wet hands. Doing so may lead to short circuits, malfunctions, or electric
shocks.
• Ensure that the power adaptor meets the requirements of Annex Q of IEC/EN 62368-1 and has been tested and approved
according to national or local standards.
• To avoid risking injury, do not touch heated parts.
• Warning: This equipment may not work when mains power fails.
Cleaning and maintenance
• During storage, transportation, and operation of the device, keep it dry and protect it from collision.
• Keep the device and accessories dry. Do not attempt to dry it with an external heat source, such as a microwave oven or
hair dryer.
• Do not expose your device or accessories to extreme heat or cold. These environments may interfere with proper function
and may lead to fire or explosion.
• Avoid collision, which may lead to device malfunctions, overheating, fire, or explosion.
• If the device is not going to be used for an extended period of time, power it off, and remove all cables connected to it.
• If anything unusual occurs (for example, if the device emits smoke or any unusual sound or smell), immediately stop using
it, power it off, and remove all cables connected to it.
• Do not trample, pull, or excessively bend any cable. Doing so may damage the cable, causing the device to malfunction.
• Before you clean or maintain the device, stop using it, stop all applications, and disconnect all cables connected to it.
• Do not use any chemical detergent, powder, or other chemical agents (such as alcohol and benzene) to clean the device
or accessories. These substances may cause damage to parts or present a fire hazard. Use a clean, soft, and dry cloth to
clean the device and accessories.
• Do not place magnetic stripe cards, such as credit cards and phone cards, near the device for extended periods of time.
Otherwise the magnetic stripe cards may be damaged.
• Do not dismantle or remanufacture the device and its accessories. This voids the warranty and releases the manufacturer
from liability for damage.
Disposal and recycling information
The symbol on the product, battery, literature, or packaging means that the products and batteries should be taken to
separate waste collection points designated by local authorities at the end of the lifespan. This will ensure that EEE waste is
recycled and treated in a manner that conserves valuable materials and protects human health and the environment.
For more information, please contact your local authorities, retailer, or household waste disposal service or visit the website
http://www.soyea-tech.com.
Reduction of hazardous substances
This device and its electrical accessories comply with local applicable rules on the restriction of the use of certain hazardous
substances in electrical and electronic equipment, such as EU REACH regulation, RoHS and Batteries (where included)
directive. For declarations of conformity about REACH and RoHS, please visit the website
http://www.soyea-tech.com
.
EU regulatory conformance
Statement
Hereby, SOYEA TECHNOLOGY CO., LTD. declares that this device B535-333 is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU.
The most recent and valid version of the DoC (Declaration of Conformity) can be viewed at http://www.soyea-tech.com.
This device may be operated in all member states of the EU.
Observe national and local regulations where the device is used.
This device may be restricted for use, depending on the local network.
Restrictions in the 5 GHz band:
The 5150 to 5350 MHz frequency range is restricted to indoor use in: AT, BE, BG, CH, CY, CZ, DE, DK, EE, EL, ES, FI, FR,
HR, HU, IE, IS, IT, LI, LT, LU, LV, MT, NL, NO, PL, PT, RO, SE, SI, SK, TR,
UK(NI)
.
In accordance with the relevant statutory requirements in the UK, the 5150 to 5350 MHz frequency range is restricted to
indoor use in the United Kingdom.
ErP Product Information
SOYEA TECHNOLOGY CO., LTD. hereby declares that its products conform to the Energy-related Products Directive (ErP)
2009/125/EC. For detailed ErP information and the user manuals required by Commission Regulation, please visit: http://
www.soyea-tech.com.
Frequency Bands and Power
(a) Frequency bands in which the radio equipment operates: Some bands may not be available in all countries or all areas.
Please contact the local carrier for more details.
(b) Maximum radio-frequency power transmitted in the frequency bands in which the radio equipment operates: The
maximum power for all bands is less than the highest limit value specified in the related Harmonized Standard.
11
To Next Page
Loading...
