SOYO SY-7VBA133U Quick Start Guide

SY-7VBA133U Quick Start Guide
20
Hard disk/FDD/ CD-ROM issue
My Western digital HDD is not detected during boot-up or No fix disk
present.
Change the jumper settings to cable select or single or remove the jumpers.
Sometimes the system finds my CD-ROM, sometimes not
1. Check CD-ROM if it is working properly
2. The power supply might not have enough wattage to support all the peripherals.
If your system has other peripherals connected, like CD-RW, extra HDD, etc.
disconnect them.
When I boot up my new computer I got "floppy boot failure" and the LED on
the floppy stays on.
Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy drive side
(don't trust the "key lock" or "notch") and use the end-connector of the cable (don't
use middle one).
USB Issues
Can I use USB port 3_4 for keyboard resume function?
This M/B has 4 USB ports, but only the 2 at the back panel can be used for USB
keyboard resume function.
I cannot get my USB working, help!
Please check if the system performance setting in the BIOS is set to maxium/Turbo,
if yes, then enable the USB by setting the system performance to normal or
manually enable the USB port (on-chip USB controller under Integrated
Peripherals).
For updated FAQs, please check http://www.soyo.com.tw/faq.htm
or
http://www.soyousa.com/faqs.html

SOYO SY-7VBA133U Specifications

General

Brand	SOYO
Model	SY-7VBA133U
Category	Motherboard
Language	English