10 | LEXI
Because dark skin is more receptive to absorb light and heat energy,
people with dark skin (Type IV) should be careful when using high-energy
gear. It is recommended to use 1-3 gear.
For those with lighter skin color (Type I-Type III), the appropriate energy
level should be selected according to their own test results. After each
operation, return to the previously operated gear. When operating the
instrument again, the interval should be more than 20 seconds.
4.4 Usage Instructions For operation
4.4.1 Using Mode introduction
• Auto mode (applicable to arms, legs and other large areas):
Selecting the auto ash mode > Press the power button > Place the light-
emitting area of the device on the treatment skin area and fully touched
to the skin > Press the ash button > The device ashing automatically >
Move the device slowly along the skin of the treatment area after
each ash > The above operation can be done back and forth twice.
It is suggested that the skin movement speed can be adjusted according to
the ash speed, so as to make the coverage more uniform. The ash rate is
faster in the rst gear, slightly slower in the second gear, and the higher the
gear, the slower the light speed.
• Manual ash mode (suitable for small areas such as ngers, lip etc.):
Selecting the manual ash mode > Press the power button > Place the
light-emitting area of the device on the treatment skin area and fully
touched to the skin > Press the ash button > Flashing once > Each time
the device is moved and the ash button is pressed, the device will
ash once > The above operation can be carried out three to four times.
4.4.2 Operation step
1. Clean your skin
- Scrape off the hair on the needed skin area (It’s better to shave hair 2
hours before machine operation).
2. Connect the power adapter
3. Wear protective glasses
- Wear the protective
To Next Page
Loading...