– 2 –
SIM Inverter Monobloc Air-to-Water Heat Pump
Benets and Features
Inverter Compressor
SIM Air-To-Water Heat Pump uses Inverter technology to
precisely match the heating or cooling load.
Advanced Controls
Unit function is managed by a parametric microprocessor allowing
on site adjustment to match specific operating requirements.
Easy Installation
The monobloc configuration keeps all refrigerant outdoors with
no refrigeration connection or handling done on site. Only the
water/antifreeze mixture is plumbed indoors.
Quiet Operation
The insulated housing, advanced fan profile, and variable speed
fan and compressor all combine to achieve a low noise level of
58dBA @ 3 meters (SIM-060) and 54dBA @ 3 meters (SIM-036).
Efficient Energy Transfer
SIM heat pump is equipped with high efficiency, large surface
area energy exchangers for both the air to refrigerant heat
transfer and the refrigerant to water energy transfer.
Low Ambient Temperature Cooling Operation
SIM heat pump is capable of operating in cooling mode in
ambient temperatures as low as 5°F.
SECTION 1: INTRODUCTION
Read Before Proceeding
Hazard Denitions
The following terms are used throughout this manual to bring
attention to the presence of potential hazards or to important
information concerning the product.
Indicates an imminently hazardous situation, which
if not avoided, WILL result in death, serious injury or
substantial property damage.
Indicates an imminently hazardous situation, which
if not avoided, COULD result in death, serious injury
or substantial property damage.
Indicates an imminently hazardous situation, which
if not avoided, MAY result in minor injury or property
damage.
Used to notify of special instructions on installation,
operation or maintenance, which are important to
equipment, but not related to personal injury hazards.
Failure to comply with these recommendations will void the warranty.