– 23 –
SIM Inverter Monobloc Air-to-Water Heat Pump
Lock Key
The lock key button will allow a user to lock the screen and
prevent un-wanted or accidental touches on the screen.
Lock Key Passcode Screen
Target Temp Set Screen
This can be adjusted by pressing the temp (on the screen) which opens a new screen and then entering in a numeric value within
specied parameters in the control (see parameter chart for min and max settings). Once a target is set, the user will need to press
“enter” to save the set point. This should return the user to the target set screen where they will see the new setpoint has been saved.
Press the return key to return to the main interface.
To unlock, simply press the lock key again and enter the code “22” when prompted. Press enter and the screen will be unlocked again.
To Next Page
Loading...
Need help?
General
