– 25 –
SIM Inverter Monobloc Air-to-Water Heat Pump
Settings Screen
Settings > Status
Under the status menu, the user can view the following status’ of the unit during real time operation
1. Unit Status (on/off). Whether the unit is operating or not
2. Present Mode: Displays the mode that the unit is running in (heating, cooling etc..)
3. Inlet Water Temp: Displays the current inlet water temperature being measured
4. Outlet Water Temp: Displays the current outlet water temperature being measured
5. Tank Water Temp: Displays the domestic hot water tank temperature, if used. If installed (see wiring diagram: eld connections
for wiring locations of tank water temperature). If not installed or not reading the display will show “- - -“
6. Ambient Temp: Will display the current ambient temperature being measured
7. Coil Temp: Will display the current coil temperature being measure on the surface of the nned coil.
8. Exhaust temp: Will display the current discharge refrigerant temperature.
To Next Page
Loading...
Need help?
General
