SPACEMAKER A24027 - End View

17
BURNER
BOTTOM
VIEW
FIG. 6
IGNITOR
CLIP
END VIEW
IGNITOR CLIP
BURNER
BURNER
ELECTRODE
ELECTRODE
FIGURE 6.
Carefully insert and snap ignitor electrode into ignitor clip as shown. Push into left hole with a twisting motion.
Push clip assembly into lower centre groove of burner as shown. Ensure clip is firmly in place by pushing the
bottom lip over the 2 bumps on the burner underside.
SP908-37 A24027-150.qxd 03/10/2003 4:45 PM Page 17