6
Figure A
The interlocking bowl guard now is available to remove for cleaning purpose. With separated handles,
it can easy take out the bowl guard and cleaning in a sink or dishwasher.
Open / Closing the Bowl Guard:
To open the bowl guard, holding the separated handle,
and rotating clockwise. (See Figure A)
To close the bowl guard, rotating counterclockwise until
the bowl guard is in the locked position. (See Figure B)
NOTE: When the guard is open or not properly installed, the
mixer will not operate.
NOTE: Removable Bowl Guard is not available for SP-A80HI,
SP-A80I, SP-B80HI and SP-B80I.
Removing and Attaching the Bowl Guard:
NOTE: Before removing or attaching the bowl guard, make sure the bowl is in
the down/lower position and the agitator is taking off from the planetary
shaft.
To remove the bowl guard, push the upper and lower part of the
separated handle in different way (upper part – counterclockwise, lower part –
clockwise) and divide the handle. (See figure C)
When the handle separated, hold the lower handle and continue turning
the guard clockwise until the guard releases from the ring catch on the mixer.
(See figure D)
To reattach the bowl guard, line up the ring catch on the
left of the mixer; lift guard gently into place and rotate the
guard’s lower handle counterclockwise until it snaps back into
place with the upper part of the handle.
SOLID SAFETY GUARD
NOTE: Solid Safety Guard is an optional accessory on SP-100A, SP-200A, SP-30HA, SP-40HA, SP-60HA,
SP-A80HI, SP-B80HI.
Solid Safety Guard is an optional accessory you can buy and use on Planetary Mixer with Removable
Safety Guard. There is an Extra Plastic Cover on Bowl Guard which can cover the entire gap on grid. The key
Operating Instructions
Figure B
To Next Page
Loading...
