Spar SP-200A - SPEED SELECTION

8
Table 2
Table 3
Noise
Model
SP-100A
and
SP-100A/nh
SP-200A
and
SP-200A/nh
SP-30HA
and
SP-30A
SP-40HA
and
SP-40A
SP-60HA
and
SP-60A
SP-A80HI,
SP-B80HI,
Noise
Level
67.3 dB 65.5 dB 64.4 dB 61.9 dB 60.1 dB 59.1 dB
SPEED SELECTION
Before changing speeds, the mixer must always be STOPPED first. The necessary speed can then be
selected before restarting the machine by pressing the Green Start Button.
NOTE: The Model SP-A80HI, SP-A80I, SP-B80HI and SP-B80I will automatically shut off if the speed is
changed during operation.
The speed selected depends largely on the quantity and consistency of the product. It is recommended
that mixing is always started at the lowest speed and progressively increased to the desired setting. In an
emergency situation always use the Red Emergency Stop Button to stop the machine. Table 2 shows the
recommended speeds for the range of tools. For Model SP-A80HI, SP-A80I, SP-B80HI and SP-B80I, please
refer to Table 3.
IMPORTANT: When mixing products always follow the recommended agitator and speed setting.
The mixer is equipped with a motor overload protection. If the mixer shuts off during operation, reduce
the batch size and wait 2 minutes. Press the stop button then press the start button.
For heavier loads, the mixer should not run longer than 15 minutes without pausing for a cool down period
of at last 15 minutes or more before resuming mixer. For lighter loads the mixer should not run longer than
30 minutes without pausing for a cool down period of at last 30 minutes or more before resuming mixer.
Recommended speed
1
st
Speed 2
nd
Speed 3
rd
Speed
Whisk
Beater
Hook
Recommended Speed
1
st
Speed 2
nd
Speed 3
rd
Speed 4
th
Speed
Whisk
Beater
Hook