Once the solder begins to flow into the wick, pull the wick and iron away at the same time.
Resources and Going Further
Wrapping It All Up
I hope this has been a fun learning adventure. Soldering is a much easier than it may seem, and can be a useful
tool for many trades and hobbies. If you still feel like you need some more help you can check out the video below.
It goes over the same steps as are mentioned here, however, sometimes seeing someone else do it is easier than
trying to explain it.
Note: Please note that the video showcases a different version of the Simon Says, but it still highlights all the
main components and shows you the proper way to assemble them.
Bootloader Note: Reprogramming the ATmega328P Microcontroller w/ Arduino!
To Next Page
Loading...
Need help?
General
