Spartus EasyCUT 40E - Installation and Use

USER’S MANUAL
EN
11
7. INSTALLATION AND USE
WARNING!
SPARTUS® EasyCUT machines are intended for professional and industrial applications.
Installation and use of the device may only be carried out appropriately trained professionals.
It is forbidden to shorten the length of the condensate drain pipe. The hose should always reach
a little above the ground - below the lower edge of the devices rear panel.
Qualified person (def.)
A person who has gained the relevant technical education, training took place and / or gained
experience to perceive the risk and avoid hazards during use of the product (IEC 60204-1).
7.1 PROPER COOLING
The unit should be placed stable on a dry and flat surface. Avoid too much slope and slippery
surfaces. Check regularly that the vents (inlet, outlet) are not covered. The minimum distance
between the machine vents and walls should be 50 [cm].
7.2 MOVEMENT AND HANDLING
Please take special care when moving the machine. It should be moved by using ofspecially
installed transport handle.
If transport handle are damaged, then it needs to be repaired at an authorized service center.
7.3 DESCRIPTION OF CONSTRUCTION
2
4
5
7
8
11
9
10
EasyCUT 40E
1
6
3