ELECTRICAL AND PEDICURE SPA COMPONENT
SPECIFICATIONS
All electrical connections MUST be made by a qualified, licensed electrician, in accordance
with Local & National Electrical and Building Codes. A 110V-50/60 Hz, 15 Amp, GFCI
protected grounded circuit MUST be used to supply power to the Pedicure Spa. A dedicated
circuit must be used with a GFCI. All wiring must conform to National & Local Electrical Codes.
!
Warning It is extremely important that the foot spa operates with GFCI protection
VERY IMPORTANT Both back of chair and seat are adjustable. When both are at maximum
positions one must allow 18”(44cm) from back wall to foot spa. This minimum distance assures
unobstructed recline. Failure to follow this required dimension might damage your spa
components and plumbing connections, which will void your warranty
PEDICURE SPA SPECIFICATIONS:
• Construction: Marble composite, high gloss, acetone-resistant gel coat.
• Two (2) electro-mechanical knobs control the drain and whirlpool.
• Electro-mechanically operated reclining, massaging, and sliding seat with hand held control.
• One (1) pipe-less whirlpool jet. (Pipe-free technology)
• Power drain or Gravity drain
• Extendable water spray positioned well above water line, air gap is accommodated with back-
flow prevention required by plumbing code
• Depending on pedicure spa model, arms may swing open, swing up / down or slide forward
/ backward.
SPECIFICATIONS
To Next Page
Loading...