OPERATION AND CARE INSTRUCTIONS
Manual Operation (For Non Auto-Fill / Drain Models):
Filling
Close the Drain Stopper by turning the Drain Knob counterclockwise. Utilizing the single lever hot/
cold mixer faucet located on the front of the Pedicure Spa, fill the tub to the water level above the
whirlpool jet at least 1 inch. You must completely submerge the jet. If during the operation of the
whirlpool, the water level decreases, simply add more water.
Whirlpool Starting
Turn the Jet Knob located on the right side of the front panel to clockwise to turn on. Turn
counterclockwise to shut off.
! Warning Do NOT turn “ON” the WHIRLPOOL JET unless adequate water is in the tub.
Draining
Turn the Drain Knob clockwise to open the Drain Stopper. Power Drain will turn on automatically if
drain pump exist.
! Warning Do NOT turn “ON” the DRAIN PUMP unless adequate water is in the tub. THE
WARRANTY IS VOID IF THE PUMP HAS BEEN RUNNING DRY
NOTE: Whirlpool action can cause even small amounts of soap or body oil to foam excessively.
For this reason, refrain from using these products during the whirlpool cycle.
User Manual Spatech | 13
To Next Page
Loading...