5. Once cleaning is nished, put the lter back on the dust container. Then insert the dust
container back into the vacuum.
5.4 Cleaning the main brush
TAKE OFF THE MAIN BRUSH
CLEANING THE MAIN BRUSH AND THE RUBBER BRUSH
5.5 Cleaning the side brushes
1. Press and lift the locking
mechanism.
1. Clean the main brush and the rubber brush
regularly with the cleaning brush.
1. Remove the screws for the side brushes
with a screwdriver.
2. Remove the side brushes and remove any
hair and remaining dirt from the brushes and
the inside of the hole.
2. Remove any hair and remaining dirt from
the main brush regularly.
2. Hold and then lift the main
brush.
3. Remove the main brushes
and the scraper.
To Next Page
Loading...