SPC Harmony - Emergency Function Sos; Setting of Numbers SOS; Using the Function SOS; Cancelling the SOS Function

45
EN
EMERGENCY FUNCTION SOS
You need to congure the SOS emergency numbers to
make use of this functionality.
Setting of numbers SOS:
From settings/Settings SOS:
• Press M1 / M3 to change the status of the function SOS
(On / Off).
• Congure the numbers SOS (SOS 1 a SOS 5,Key *, key #).
• Type the help message to be sent to SOS numbers.
Press SAVE to save the changes.
Using the function SOS
During an emergency, hold down the SOS button for a
few seconds. The terminal will beep alert and send SOS
messages to pre-dened numbers.
Then the call cycle starts. Activate the speaker phone and
call the SOS numbers in consecutive order until one of them
responds.
Cancelling the SOS function:
If you have activated the SOS function by mistake, you can
stop calling by pressing the SOS button for a few seconds.